project before lockdown to try and make it easier for us so we dont have as much pressure on us to complete it. Today in this blog I will be going through the steps with you on how we made it.
1:Get some 20 mm wide and 3 mm thick mild steel and cut it so it is 112 mm long .
2: File the work down to 110 mm then find the middle line and mark 10mm down in and then do a 10 mm radius at the other end go 5 in at the end and 5 across and make angle on it.
3:Heat the end up then put in carbon and harden the end and then polish it.
4. Put a suit on to protect yourself from the flames.
5. Grab your work and heat it up until you like the colour and then dip it in the oil until the smoke goes away or count to 100 seconds, take it out clean it with a rag and then you are done.
Here is a picture of my finished project.
Below is the equipment we used to make this happen
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.